Windshield defrosting and defogging
WARNING - Windshield heating
Do not use the 
or
position during cooling operation in
extremely humid weather. The difference between the temperature of the outside air
and that of the windshield could cause the outer surface of the windshield to fog
up, causing loss of visibility. In this case, set the mode selection knob or button
to the 
position and fan speed control
knob or button to a lower speed.
• For maximum defrosting, set the temperature control to the extreme right/hot position and the fan speed control to the highest speed.
• If warm air to the floor is desired while defrosting or defogging, set the mode to the floor-defrost position.
• Before driving, clear all snow and ice from the windshield, rear window, outside rear view mirrors, and all side windows.
• Clear all snow and ice from the hood and air inlet in the cowl grill to improve heater and defroster efficiency and to reduce the probability of fogging up the inside of the windshield.
See also:
Engine Compartment
The following should be checked regularly:
o Engine oil level and condition
o Transaxle fluid level and condition
o Brake fluid level
o Clutch fluid level
o Engine coolant level
o Windshield was ...
Key positions
Key positions
CAUTION:
The engine should not be turned off or the
key removed from the ignition key cylinder
while the car is in motion. The steering
wheel is locked by removing the key.
o &qu ...
Windshield wiper blades
The wiper blades should be carefully inspected
from time to time and cleaned to remove accumulations
of road film or other debris. To clean
the wiper blades and arms, use a clean sponge
or cloth ...