Automatic climate control system

To defog inside windshield


To defog inside windshield

1. Select desired fan speed.

2. Select desired temperature.

3. Press the defrost button ( 4. The outside (fresh) air position will be selected automatically.).


4. The outside (fresh) air position will be selected automatically.

If the outside (fresh) air position is not selected automatically, adjust the corresponding button manually.

If the fan speed is adjusted to a higher fan speed. position is selected, lower
fan speed is adjusted to a higher fan speed.

To defrost outside windshield


To defrost outside windshield

1. Set the fan speed to the highest (extreme right) position.

2. Set the temperature to the extreme hot (HI) position.

3. Press the defrost button (4. The outside (fresh) air position will be selected automatically.).


4. The outside (fresh) air position will be selected automatically.

If the fan speed is adjusted to a higher fan speed. position is selected, lower
fan speed is adjusted to a higher fan speed.

    See also:

    Closing the trunk
    To close the trunk, lower the trunk lid, then press down on it until it locks. To be sure the trunk lid is securely fastened, always check by trying to pull it up again. WARNING The trunk lid sh ...

    Engine number
    The engine number is stamped on the engine block as shown in the drawing. ...

    If the Engine Overheats
    If your temperature gauge indicates overheating, you experience a loss of power, or hear loud pinging or knocking, the engine is probably too hot. If this happens, you should: 1. Pull off the roa ...