Brake/clutch fluid
Check brake fluid level in the brake fluid reservoir. The level should be between “MIN” and “MAX” marks on the side of the reservoir. Use only hydraulic brake fluid conforming to DOT 3 or DOT 4 specification.
See also:
Higher speed motoring
Pre-Trip Inspections
1. Tires:
Adjust the tire inflation pressures to specification.
Low tire inflation pressures will result in
overheating and possible failure of the tires.
Avoid using worn or ...
Engine Coolant Temperature Warning Light
WARNING:
Never remove the radiator cap when the engine is hot. The engine coolant is
under pressure and could erupt and cause severe burns. Wait until the engine is
cool before removing the rad ...
Lower Vehicle and Tighten Nuts
Lower the car to the ground by turning the wheel nut wrench counterclockwise.
Then position the wrench as shown in the drawing and tighten the wheel nuts. Be
sure the socket is seated completely ...


