DEFROSTING/DEFOGGING


Use the heating/ventilation system to defrost or defog the windshield:


Use the heating/ventilation system to defrost or defog the windshield:

To remove interior fog on the windshield; o Set the air flow control to the defrost (position (The A/C will automatically be turned on and "Fresh" mode will be activated.).)
position (The A/C will automatically be turned on and "Fresh" mode will be activated.).

o Set the temperature control to the desired position.

o Set the fan speed control between "1" and "4" position.

To remove frost or exterior fog on the windshield; o Set the air flow control to the defrost (position (The A/C will automatically be turned on and "Fresh" mode will be activated.).)
position (The A/C will automatically be turned on and "Fresh" mode will be activated.).

o Set the temperature control to warm.

o Set the fan speed control to position "3" or "4".

NOTE:

When the A/C is operated continuously on the floor-defrost level (or defrost level (), it may cause fog)
or defrost level (to form on the exterior windshield. If this occurs, set the air flow control to), it may cause fog
to form on the exterior windshield. If this occurs, set the air flow control to the face level position (control to the low position.) and fan speed
control to the low position.

    See also:

    Theft-alarm stage
    The alarm will be activated if any of the following occurs while the system is armed. • A door is opened without using the transmitter (or smart key or mechanical key). • The trunk is opened wit ...

    High mounted stop light replacement
    If the light is not operating, have the vehicle checked by an authorized HYUNDAI dealer. ...

    Antenna
    Glass antenna (if equipped) When the radio power switch is turned on while the ignition key is in either the “ON” or “ACC” position, your car will receive both AM and FM broadcast signals throug ...