Heating and air conditioning

1. Start the engine.

2. Set the mode to the desired position. To improve the effectiveness of heating and cooling :
- Heating:- Cooling:
- Cooling: 3. Set the temperature control to the desired position.
3. Set the temperature control to the desired position.

4. Set the air intake control to the outside (fresh) air or recirculated air position.

5. Set the fan speed control to the desired speed.

6. If air conditioning is desired, turn the air conditioning system on.

Mode selection


    See also:

    Compliance Label
    The compliance label is located on the driver's side of the center pillar outer panel. The label shows the maximum allowable weight of the fully loaded vehicle. This is called the GVWR (Gro ...

    Adjusting Armrest Angle (Driver's side only)
    The armrest will be raised or lowered manually. To raise the armrest, pull it up. To lower it, press the armrest down. ...

    Checking drive belts
    Drive belts should be checked periodically for proper tension and adjusted if necessary. At the same time, belts should be examined for cracks, wear, fraying or other evidence of deterioration a ...