Hazard warning flasher
The hazard warning flasher should be used whenever you find it necessary to stop the car in a hazardous location. When you must make such an emergency stop, always pull off the road as far as possible.
The hazard warning lights are turned on by pushing in the hazard switch. This causes all turn signal lights to blink. The hazard warning lights will operate even though the key is not in the ignition switch.
To turn the hazard warning lights off, push the switch a second time.
See also:
If You Have a Flat Tire
If a tire goes flat while you are driving:
1. Take your foot off the accelerator pedal and let the car slow down while driving
straight ahead. Do not apply the brakes immediately or attempt to pull ...
Headlight aiming adjustment
Before performing aiming adjustment, make
sure of the following.
1. Keep all tires inflated to the correct pressure.
2. Place the vehicle on level ground and press
the front bumper & rear bump ...
Map Light
o Push in the map light switch to
turn the light on or off.
o Push in the map light switch to
turn the light on or off.
o "DOOR"
In the "DOOR" position, the map light ...