Put the Jack in Place
The base of the jack should be placed on firm, level ground. The jack should be positioned as shown in the drawing.
See also:
Vacuum crankcase ventilation hoses
Inspect the surface of hoses for evidence of heat and/or mechanical damage. Hard
and brittle rubber, cracking, tears, cuts, abrasions, and excessive swelling indicate
deterioration. Particular att ...
Fuse panel description
Engine Compartment
NOTE:
Not all fuse panel descriptions in this manual may be applicable to your
vehicle. It is accurate at the time of printing. When you inspect the
fuse box on your vehicl ...
Lower Vehicle and Tighten Nuts
Lower the car to the ground by turning the wheel nut wrench counterclockwise.
Then position the wrench as shown in the drawing and tighten the wheel nuts. Be
sure the socket is seated completely ...