Hazard warning flasher
The hazard warning flasher should be used whenever you find it necessary to stop the car in a hazardous location. When you must make such an emergency stop, always pull off the road as far as possible.
The hazard warning lights are turned on by pushing in the hazard switch. This causes all turn signal lights to blink. The hazard warning lights will operate even though the key is not in the ignition switch.
To turn the hazard warning lights off, push the switch a second time.
See also:
Tail gate
o Pull and raise the "DOOR" release lever to
open the tail gate.
o To close, lower the door, then press down on
it until it locks. To be sure the door is securely
fastened, try to pull ...
Replacing a Fusible Link
A fusible link will melt if the electrical circuits from the battery are ever
overloaded, thus preventing damage to the entire wiring harness. (This could be
caused by a short in the system draw ...
Cooling system
Check cooling system components, such as radiator, coolant reservoir, hoses and
connections for leakage and damage. Replace any damaged parts. ...