To start the engine
COMBINATION IGNITION SWITCH
o If your Hyundai is equipped with a manual transaxle, place the shift lever in neutral and depress the clutch pedal fully.
o If your Hyundai has an automatic transaxle, place the shift lever in "P" (park).
o To start the engine, insert the ignition key and turn it to the "START" position. Release it as soon as the engine starts. Do not hold the key in the "START" position for more that 15 seconds.
NOTE:
o For safety, the engine will not start if the
clutch pedal is not depressed fully
(Manual Transaxle) or the shift lever is
not in "P" or "N" Position (Automatic
Transaxle).
o The ignition key cannot be turned from "ACC" position to "LOCK" position unless the shift lever is in the "P" (Park) position or the negative battery terminal is disconnected from the battery. To remove the key, always confirm that the shift lever is securely positioned in "P" (Park) (For Automatic Transaxle).
See also:
Using a cellular phone or a twoway radio
When a cellular phone is used inside the vehicle, noise may be produced from
the audio equipment. This does not mean that something is wrong with the audio equipment.
In such a case, use the cellu ...
Low Oil Pressure Warning Light
CAUTION:
If the oil pressure warning light stays on while the engine is running, serious
engine damage may result. The oil pressure warning light comes on whenever there
is insufficient oil pre ...
To increase cruise control set speed
Follow either of these procedures:
o Push the RES/+ switch and hold it. Your vehicle will accelerate. Release the switch
at the speed you want.
o Push the RES/+ switch and release it immediately ...