Re-install Wheel Nuts
To reinstall the wheel cover, hold it on the studs, put the wheel nuts on the studs and tighten them finger tight. The nuts should be installed with their small diameter ends directed inward. Jiggle the tire to be sure it is completely seated, then tighten the nuts as much as possible with your fingers again.
See also:
SRS components and functions
The SRS consists of the following components:
1. Driver's front air bag module
2. Passenger's front air bag module
3. Side impact air bag modules
4. Curtain air bag modules
5. Retractor ...
Smooth cornering
Avoid braking or gear changing in corners,
especially when roads are wet. Ideally, corners
should always be taken under gentle acceleration.
If you follow these suggestions, tire wear
will be held ...
Outside rearview mirror
Be sure to adjust mirror angles before driving.
Your vehicle is equipped with both lefthand and right-hand outside rearview mirrors.
The mirrors can be adjusted remotely with the remote switch. The ...