Loosen Wheel Nuts
The wheel nuts should be loosened slightly before raising the car. To loosen the nuts, turn the wrench handle counterclockwise. When doing this, be sure that the socket is seated completely over the nut so it cannot slip off. For maximum leverage, position the wrench so the handle is to the right. Then, while holding the wrench near the end of the handle, pull up on it with steady pressure. Do not remove the nuts at this time. Just loosen them about one-half turn.
See also:
Map Light
1. Remove the cover with a flat-head screwdriver.
2. Replace with a new bulb. ...
To Keep Locks from Freezing
To keep the locks from freezing, squirt an approved de-icer fluid or glycerine
into the key opening. If a lock is covered with ice, squirt it with an approved
de-icing fluid to remove the ice. If ...
Emission Control System
Your Hyundai is equipped with an emission control system to meet all requirements
of the U.S. Environmental Protection Agency or California Air Resources Board.
There are three emission control sys ...