DEFROSTING/DEFOGGING
Use the heating/ventilation system to defrost or defog the windshield:
To remove interior fog on the windshield;
o Set the air flow control to the defrost ()
position (The A/C will automatically be turned on and "Fresh" mode will be activated.).
o Set the temperature control to the desired position.
o Set the fan speed control between "1" and "4" position.
To remove frost or exterior fog on the windshield;
o Set the air flow control to the defrost ()
position (The A/C will automatically be turned on and "Fresh" mode will be activated.).
o Set the temperature control to warm.
o Set the fan speed control to position "3" or "4".
NOTE:
When the A/C is operated continuously on the floor-defrost level ()
or defrost level (), it may cause fog
to form on the exterior windshield. If this occurs, set the air flow control to
the face level position () and fan speed
control to the low position.
See also:
Use Approved Anti-Freeze in Window Washer System
To keep the water in the window washer system from freezing, add an approved
anti-freeze solution in accordance with instructions on the container. Window washer
anti-freeze is available from Hyun ...
Spare Tire Pressure
2. The spare tire should only be used temporarily and should be returned to the
luggage compartment as soon as the original tire can be repaired or replaced.
3. Continuous use at speeds of over 5 ...
Battery replacement
A smart key battery should last for several years, but if the smart key is not
working properly, try replacing the battery with a new one. If you are unsure how
to use your smart key or replace ...