Windshield Wiper
The windshield wiper switch has three positions:
A) Intermittent wiper operation
B) Low-speed operation
C) High-speed operation
NOTE:
To prevent damage to the wiper system, do not attempt to wipe away heavy accumulations of snow or ice. Accumulated snow and ice should be removed manually. If there is only a light layer of snow or ice, operate the heater in the defrost mode to melt the snow or ice before using the wiper.
See also:
Tire sidewall labeling
This information identifies and describes the fundamental characteristics of
the tire and also provides the tire identification number (TIN) for safety standard
certification. The TIN can be use ...
Tail gate
o Pull and raise the "DOOR" release lever to
open the tail gate.
o To close, lower the door, then press down on
it until it locks. To be sure the door is securely
fastened, try to pull ...
Key Positions
WARNING:
The engine should not be turned off or the key removed from the ignition key
cylinder while the vehicle is in motion. The steering wheel is locked by removing
the key.
o "START&q ...