Transmitter precautions

NOTICE

The transmitter will not work if any of following occur:

The ignition key is in ignition switch.

You exceed the operating distance limit (about 90 feet [30 m]).

The battery in the transmitter is weak.

Other vehicles or objects may be blocking the signal.

The weather is extremely cold.

The transmitter is close to a radio transmitter such as a radio station or an airport which can interfere with normal operation of the transmitter. When the transmitter does not work correctly, open and close the door with the ignition key. If you have a problem with the transmitter, contact an authorized HYUNDAI dealer.

CAUTION

Keep the transmitter away from water or any liquid. If the keyless entry system is inoperative due to exposure to water or liquids, it will not be covered by your manufacturers vehicle warranty.

This device complies with Part 15 of the FCC rules.

Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and

2. This device must accept any interference received, including interference that may cause undesired operation.

WARNING

Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. If the keyless entry system is inoperative due to changes or modifications not expressly approved by the party responsible for compliance, it will not be covered by your manufacturers vehicle warranty.

    See also:

    Turn Signal Operation
    Pulling down on the lever causes the turn signals on the left side of the car to blink. Pushing upward on the lever causes the turn signals on the right side of the car to blink. As the turn is co ...

    Going & Stopping
    The Santa Fe is offered with a choice of two V-6 engines. The base GLS has a 2.7-liter V-6 while the midlevel SE and top-of-the-line Limited the trim level I tested feature a larger 3.3-liter ...

    Checking the engine oil level
    1. Be sure the vehicle is on level ground. 2. Start the engine and allow it to reach normal operating temperature. 3. Turn the engine off and wait for a few minutes (about 5 minutes) for the oil ...